How do I change a sink faucet?

When choosing a sink faucet, consider the height and type of spout, the method of opening, and the decorative style. But there are additional features that make life easier. While some plumbing jobs require the help of a professional, others can be done on their own. Here are the different steps to easily replace the sink faucet accessory.

The first steps to take

Once you have found the model of faucet you want to install on the sink, you need to take measurements, for this, find out here. In fact, the center distance must be measured before buying a mixer. This is the distance between the centers of the two threaded holes. Since this is a single-hole faucet, you need to know its diameter. In fact, most of these devices have standard diameters. Next, you will need to check the pipe. Before you replace the valve, make sure you check the condition of the pipe. You need to pay attention to the connection of the pipes and supply lines.
To do this, loosen the drain hose and check if the seal is still working properly. If not, the hose should be replaced. Now turn off the water supply. Once you have all the necessary equipment to replace the sink faucet, you need to turn off the water supply. This means turning off the valve, which is usually located under the sink. If you can't find it there, you need to turn off the main water supply outside the house. Then open the valve to drain the water from the distribution pipe.

The steps to follow

At this point, remove the old faucet. Once all the water has been drained, you can separate the faucet from the water supply pipe and remove it from the sink. Keep in mind that some installations can be very flexible, while others are more difficult. Also, place a bucket underneath to catch any water that may be left in the drain. Since your sink has a mechanical drain, remove the actuator from the lever. Then use a wrench to remove the fastener. Now comes the phase of installing a new faucet. In order to properly assemble your new faucet, you must follow the instructions provided with the product. In fact, the installation system of the equipment may vary from one manufacturer to another.
Therefore, it is necessary to understand and follow the product instructions to ensure a quality installation. Later, you will need to use sealant or silicone sealant to secure the faucet. Place it on the base and insert the cigarette butt. Place the fixing nut and the supply pipe. Avoid over-tightening. After installing the faucet, all you have to do is connect the water supply hose to the stopcock. It is best to tighten the nut by hand. For installations with a mechanical drain, remember to reconnect the actuator to the lever before screwing on the fixing nut. Once everything is set up, you can open the water supply that was previously closed. Drain the equipment and check that the valve is operating normally.